User Tools

Site Tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revisionBoth sides next revision
hacking_an_eq-3_model_n [2016/03/22 14:39] – [How the Model N Looks Inside] Traumflughacking_an_eq-3_model_n [2016/03/22 15:15] – [The Hack in Pictures] Add all the pictures with descriptions. Traumflug
Line 61: Line 61:
 During the modification a lot of pictures were taken, so let's speak these. During the modification a lot of pictures were taken, so let's speak these.
  
-picture picture +{{ :eq-3:eq-3_model_n_thermistor_removed.jpeg?direct&300 |First step is to remove the Thermistor. Try to heat it on both sides, then shove it away.}} | {{ :eq-3:eq-3_model_n_wires_instead_of_thermistor.jpeg?direct&300 |Then solder a wire to each of the pads. Requires lots of flux and a steady hand :-)}} 
 +| {{ :eq-3:eq-3_model_n_wire_hole.jpeg?direct&300 |Drill up one of the venting holes in the battery cover. Wires will go through here.}} | {{ :eq-3:eq-3_model_n_wiring.jpeg?direct&300 |Then make a knot into the wire pair and run it through the cover hole. This means to be a stress relief, so you don't rip the circuitry apart if you accidently trip over the wire.}} | 
 +| {{ :eq-3:eq-3_model_n_thermistor_on_wire.jpeg?direct&300 |After doing the wiring on the PCB side, solder the thermistor removed earlier back onto the other end of the wire pair. Again, this might take a few tries.}} | {{ :eq-3:eq-3_model_n_thermistor_insulated.jpeg?direct&300 |As you might mount the thermistor to some metallic surface, insulation of that is a good idea. This is Kapton tape, but its high temperature resistance isn't needed here.}} | 
 +| {{ :eq-3:eq-3_model_n_ready_with_external_thermistor.jpeg?direct&500 |Assemble everything back together and you're done. That's how the EQ-3 Model N with DIY'd external thermistor looks like.}} ||
 ===== How the Result Works ===== ===== How the Result Works =====
  
hacking_an_eq-3_model_n.txt · Last modified: 2018/05/27 16:10 (external edit)