User Tools

Site Tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
thermistor_troubleshooting [2016/04/16 17:35] – [Check Thermistor Wiring] Traumflugthermistor_troubleshooting [2018/05/27 16:10] (current) – external edit (unknown user)
Line 32: Line 32:
 ==== Check Thermistor Wiring ==== ==== Check Thermistor Wiring ====
  
-This measurement is simple, too. Unplut the thermistor connector and measure resistance between both pins there. At room temperature this should be around the nominal value of the thermistor, typically 10\_kOhms or 100\_kOhms. Warming the thermistor by hand should reduce this resistance by a few kOhms.+This measurement is simple, too. Unplug the thermistor connector and measure resistance between both pins there. At room temperature this should be around the nominal value of the thermistor, typically 10\_kOhms or 100\_kOhms. Warming the thermistor by hand should reduce this resistance by a few kOhms.
  
 Measuring the thermistor while it's plugged in gives false results. Measuring the thermistor while it's plugged in gives false results.
Line 46: Line 46:
 This measurement can be done without the processor installed. If one is installed, the firmware shouldn't make these pins an output, but keep the default, input. This measurement can be done without the processor installed. If one is installed, the firmware shouldn't make these pins an output, but keep the default, input.
  
-Without a thermistor connected, both pins should read full 3.3\_volts (5\_volts on 5\_V controllers). Connecting a thermistor at room temperature should drop this not much, but a bit. Typically to 3.1\_... 3.2\_volts.+Without a thermistor connected, both pins should read full 3.3\_volts (5\_volts on 5\_V controllers). Connecting a thermistor at room temperature (not to these processor pins, but to the thermistor header on the board) should drop this not much, but a bit. Typically to 3.1\_... 3.2\_volts.
  
 Warming the thermistor by hand might change that slightly, perhaps by another 0.05\_V drop. Warming the thermistor with a lighter or soldering iron (be careful to not overheat it!), should drop that voltage further, down to very low readings, like 0.5\_V. Warming the thermistor by hand might change that slightly, perhaps by another 0.05\_V drop. Warming the thermistor with a lighter or soldering iron (be careful to not overheat it!), should drop that voltage further, down to very low readings, like 0.5\_V.
thermistor_troubleshooting.txt · Last modified: 2018/05/27 16:10 (external edit)